English
Japanese
 
   

C-band Optical Fiber Amplifier (EDFA)
The AMP-FL801x-CB series are optical fiber amplifiers for C-band. The FL8011-CBs are intended for the uses as booster amplifiers, while the FL8013-CBs are suitable as pre-amplifiers. Its superior performance such as high gain, flat gain spectra without any filter, and low noise over broad bandwidth is based on the use of an erbium doped fiber gain module.
Features
  • High saturation output power up to 22 dBm
  • Excellent noise figure
  • Excellent gain flatness
  • Low analog distortion
  • Competitively priced
  • Output power & pumping current monitoring
  • ACC/ALC mode operation
Applications
  • DWDM, Telecom, Datacom
  • Analog applications
  • Test & measurement
  • Scientific Applications
Standard Specifications
Applications Booster and In-line Amplifier Pre and In-line Amplifier
Item AMP-FL8011-CB-xx(-W) AMP-FL8013-CB-xx(-W)
-21-W -22 -19 -16 -19-W -19 -16 -13
Signal Wavelength 1530~1560
nm (DWDM)		 1530 ~ 1560nm 1530~1560
nm (DWDM)		 1530 ~ 1560nm
Maximum Output Power *1 >+21dBm
( >125mW)		 >+22dBm
( >160mW) 		>+19dBm
( >80mW)		 >+16dBm
( >40mW)		 >+19dBm
( >80mW)		 >+19dBm
( >80mW)		 >+16dBm
( >40mW)		 >+13dBm
( >20mW)
Gain *2 - >40dB >35dB >30dB - >35dB >30dB >25dB
Noise Figure *2 <6dB <5dB
Amplifier control ACC / ALC
Monitor Optical output power, Pumping current
Input/Output Fibers SMF
Optical connectors FC/PC
Operation Temperature 0 ~ 40 °C
Storage Temperature -10 ~ 60 °C
Size(mm) (H)x(W)x(D) *3 88 x 336 x 352 88 x 230 x 352 88 x 336 x 352 88 x 230 x 352
Weight 7 Kg 5 Kg 7 Kg 5 Kg
Power Supply AC 100~240V (50/60Hz)

*1 Input Power: >0dBm@1550nm
*2 Input Power: -30dBm@1550nm
*3 Not Including Protrusions

  • The specifications are subject to change.
  • All functions, characteristics and exterior design can be optimized according to customer requirements, and please feel free to contact FiberLabs sales engineer
Products / About FiberLabs / Technology / Contact Us
Copyright(C) FiberLabs Inc. All Rights Reserved.